You can download and install (works only on Windows XP) from here: https://drive.google.com/file/d/0B2Jyt6TfySBwLV9weXRPRWV0c3c/view?usp=sharing
If your two terminals are working but only one is showing a “Station starting…” or “Station stopped” message then it is most likely a driver issue. Go into the Device Manager (by right clicking on My Computer, choosing properties and then going to the Hardware tab and then clicking the Device Manager button) and under […]
Unfortunately, there was an error in some of the PC-Station CDs that caused it to ask you to correct the date when it is already the correct (Gregorian) date. To do the installation, browse the CD, go in to the PC-Station folder on the CD and then run the file “pcstn.exe”. This will start the […]
This is usually caused by a software called Deep Freeze. If you have it installed then make sure you disable it (by holding the shift key and double clicking on the Deep Freeze icon near the system time, bottom right of your screen) and then restarting your system 2 or 3 times until the keyboard […]
Yes, it is incompatible with Dell Optiplex 745, 755 and 360/380. It will also not work on some assembled computers with the Intel G33/31 Express chipset. Dell Optiplex 760 and 780 are compatible and can be used if their BIOS versions are above 8. You can check this when you computer first boots up (as […]
This can be caused by one of two things. You have not entered serial numbers for all the stations. In this case, you will see a prompt on the host (main) computer asking you to enter a serial number. You can get the serial numbers on the back of each terminal (small black box) You […]
Yes, this is a must! You need to install the VGA (Graphics) driver for your computer before you can install and use the Multipoint driver software. You need to locate and install the VGA driver compatible with Windows 7, 64-bit. Here are some drivers (download links) for a few common computer models (for Windows Multipoint […]
An authorization error usually occurs when more than one system in a LAN has the same serial numbers assigned to the system. In this case, the first PC to be turned on does not suffer an authorization error, but any subsequent PC’s which contain the same serial number will experience the issue. To remove these duplicate serial numbers, […]
If the color on your station’s screen is bad, clouded over with green, yellow, red etc as seen in the picture below then this is most probably a network cable or a VGA cable issue. To fix this problem, Make sure your monitors VGA cable is working (try using another one that is known to […]
This can be caused by one of two reasons You have an anti-virus or firewall software blocking the pc-station software from starting. In this case, just uninstall all anti-virus software (such as Kaspersky, Avira, AVG and Avast) and then restart you computer. The stations should now start working. If you have Kaspersky installed, you might […]
